Server features and specifications – Lenovo System x3100 M4
- Supports one Intel quad-core (Xeon E3-1200 series) or dual-core
(Pentium G850, or Core i3 series) processor - Multi-chip Package processor architecture
- Designed for LGA 1155 socket
- Scalable up to four cores
- 32 KB instruction L1 cache, 32 KB data L1 cache, 256 KB instruction/data
L2 cache, and up to 8 MB L3 cache that is shared among the cores - Support for Intel Extended Memory 64 Technology (EM64T)
note :
- Use the Setup utility to determine the type and speed of the microprocessors
in the server. - For a list of supported microprocessors, see the Lenovo ServerProven website.
Memory:
- Connectors: four dual inline memory module (DIMM) connectors,
two-way interleaved- Minimum: 1 GB
- Maximum: 32 GB
- Types: PC3-12800 (single-rank or dual-rank), 1066, 1333 and 1600
MHz, ECC, DDR3 unbuffered SDRAM DIMMs only- Sizes: 1GB (single-rank) 2GB (single-rank) 4GB (dual-rank) 8GB
(dual-rank)
- One system fan
Power supply: one operating room two pleonastic 430-watt exponent provision
Size:
- Height: 438.60 mm (17.27 in.)
- Depth: 569.11 mm (22.41 in.)
- Width: 217.25 mm (8.56 in.)
- Weight: 19.6 kg (43 lb) to 21.4 kg (47 lb) depending upon configuration
- ServeRAID-BR10il v2 SAS/SATA adapter that provides RAID levels
0, 1, and 10.
Environment:
- Air temperature:
- Server on: 10°C to 35°C (50°F to 95°F) Altitude: 0 to 914.4 m
(3000 ft) - Server on: 10°C to 32°C (50°F to 89.6°F) Altitude: 914.4 m (3000
ft) to 2133.6 m (7000 ft) - Server on: 10°C to 28°C (50.0°F to 83°F); altitude: 2133.6 m (7000
ft) to 3050 m (10000 ft) - Server off: 10°C to 43°C (50°F to 109.4°F)
- Shipping: -40°C to 60°C (-40°F to 140°F)
- Server on: 10°C to 35°C (50°F to 95°F) Altitude: 0 to 914.4 m
- Humidity (operating and storage): 8% to 80%
- Particulate contamination:
attention : Airborne particulates and reactive gases
acting alone or in combination with other environmental factors such
as humidity or temperature might pose a risk to the server. For information
about the limits for particulates and gases, see airborne particulate and reactive gas acting alone oregon in combination with other environmental factor such vitamin a humidity operating room temperature might pose a risk to the server. For information about the limit for particulate and natural gas, visit particulate contaminant
- Hard disk drives: up to eight 2.5-inch hot-swap SATA
- One of the following SATA attached optical drives:
- DVD-ROM
Drives bays:
- Two 5.25-inch half-high bays (one optical drive installed).
- Eight 2.5-inch hard disk drive bays
Attention:
ampere ampere general retainer, cause not shuffle standard 512-byte and advanced 4-KB format drive indiana the lapp raid array because information technology might contribute to potential performance issue .
- Integrated management module II (IMM2), which consolidates multiple
management functions in a single chip - Intel 82574L Gb Ethernet controller with TCP/IP Offload Engine
(TOE) and Wake on LAN support - Integrated SATA controller
- Seven Universal Serial Bus (USB) 2.0 ports (two front, four rear
of the chassis, and one internal for an optional tape drive) - Six SATA ports (four for simple-swap hard disk drives and two
for the DVD drive and the optional tape drive) - One serial port
- Two Ethernet port
- One VGA port
- Minimum configuration: 341 Btu per hour (100 watts)
- Maximum configuration: 1726 Btu per hour (506 watts)
Electrical input:
Read more : IBM System/360 – Wikipedia
- Sine-wave input (50 or 60 Hz) required
- Input voltage and frequency ranges automatically selected
- Input voltage low range:
- Minimum: 100 V ac
- Maximum: 127 V ac
- Input voltage high range:
- Minimum: 200 V ac
- Maximum: 240 V ac
- Input kilovolt-amperes (kVA) approximately:
- Minimum: 0.100 kVA (all models)
- Maximum: 0.506 kVA
- One PCI Express x16 slot
- One PCI Express x8 slot
- One PCI Express x4 slot
- One PCI Express x1 slot
- Sound power, idling: 5.0 bels
- Sound power, operating: 5.3 bels
- Power consumption and heat output vary depending on the number
and type of optional features installed and the power-management optional
features in use. - These levels were measured in controlled acoustical environments
according to the procedures specified by the American National Standards
Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance
with ISO 9296. Actual sound-pressure levels in a given location might
exceed the average values stated because of room reflections and other
nearby noise sources. The declared sound-power levels indicate an
upper limit, below which a large number of computers will operate.