Dịch Vụ Sửa Chữa 24h Tại Hà Nội

Server features and specifications – Lenovo System x3100 M4

table two. feature of speech and specification for the 5U server model with hot-swap power issue ( mannequin diagnose : 2582-F4x ). For 4U server model with non-hot-swap power supply, please see table one . Microprocessor (depending on the model):

note :

Memory:

  • Connectors: four dual inline memory module (DIMM) connectors,
    two-way interleaved
  • Minimum: 1 GB
  • Maximum: 32 GB
  • Types: PC3-12800 (single-rank or dual-rank), 1066, 1333 and 1600
    MHz, ECC, DDR3 unbuffered SDRAM DIMMs only
  • Sizes: 1GB (single-rank) 2GB (single-rank) 4GB (dual-rank) 8GB
    (dual-rank)
Fan:

Power supply: one operating room two pleonastic 430-watt exponent provision
Size:

RAID (depending on model):

Environment:

attention : Airborne particulates and reactive gases
acting alone or in combination with other environmental factors such
as humidity or temperature might pose a risk to the server. For information
about the limits for particulates and gases, see airborne particulate and reactive gas acting alone oregon in combination with other environmental factor such vitamin a humidity operating room temperature might pose a risk to the server. For information about the limit for particulate and natural gas, visit particulate contaminant

Drives (depending on the model):

Drives bays:

Attention:

ampere ampere general retainer, cause not shuffle standard 512-byte and advanced 4-KB format drive indiana the lapp raid array because information technology might contribute to potential performance issue .

Integrated functions: Heat output: approximate inflame output :

Electrical input:

Expansion slots: Acoustical noise emissions: note :
  1. Power consumption and heat output vary depending on the number
    and type of optional features installed and the power-management optional
    features in use.
  2. These levels were measured in controlled acoustical environments
    according to the procedures specified by the American National Standards
    Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance
    with ISO 9296. Actual sound-pressure levels in a given location might
    exceed the average values stated because of room reflections and other
    nearby noise sources. The declared sound-power levels indicate an
    upper limit, below which a large number of computers will operate.
beginning : https://dichvusuachua24h.com
class : IBM